Operators Manual
Table Of Contents
- Contents
- 1. Introduction
- 2. Safety Precautions
- 3. Specifications
- 4. Troubleshooting
- 5. Engine
- 6. Rewind Starter
- 7. Control Levers
- 8. Fuel System
- 8.1 Air Filter
- 8.2 Removing and Installing the Carburetor
- 8.3 Leakage Test
- 8.4 Servicing the Carburetor
- 8.5 Adjusting the Carburetor
- 8.6 Removing and Installing Throttle Cable (Loop Handle)
- 8.7 Removing and Installing the Spacer Flange
- 8.8 Tank Vent
- 8.9 Fuel Intake
- 8.10 Removing and Installing the Engine Housing
- 9. Drive Tube
- 10. Special Servicing Tools
- 11. Servicing Aids
75Series 4144 Components FC, FS, KM
: Take out the screw (arrow).
– Remove the line limiting blade
(1), check and sharpen or replace
as necessary.
: Push the line limiting blade (1)
into its seat (arrow).
– Insert screw and tighten it down
firmly.
To avoid stripping the thread in the
plastic housing, carefully locate
screw in existing thread and tighten
in down.
– Check the gearbox, repair or
replace as necessary – see
"KombiTools" service manual.
1
545RA270 TG
1
545RA009 TG
– Locate deflector (1) against the
gearbox.
: Insert screw (arrow) and tighten it
down firmly.
– Reassemble all other parts in the
reverse sequence.
9.2.3 One-part Carrying Ring
: Take out the screw (2), bend
open the clamp (1) and remove it.
– Reassemble in the reverse
sequence.
1
545RA269 TG
2
1
545RA271 TG
9.2.4 Retainer
– Remove the drive tube, b 9.1
: Pull off the throttle cable retainer.
– Reassemble in the reverse
sequence.
9.3 Gearbox
Refer to "KombiTools" service
manual for descriptions of servicing
procedures on the gearbox.
545RA272 TG