Instruction Manual

FSA 65, FSA 85
English
14
Adjusting Nylon Line
N Hold the rotating mowing head
above the ground – tap it on the
ground once – about 1.2 in. of fresh
line is advanced.
The blade (1) on the deflector (2) trims
surplus line to the correct length – avoid
tapping the mowing head more than
once at a time.
Line feed operates only if both lines still
have a minimum length of 1.0 in.
If the line is shorter than 1.0 in:
N Switch off the trimmer.
N Move the retaining latch to ƒ and
remove the battery.
N Turn the trimmer on its back.
N Press down the cap on the spool as
far as stop.
N Pull the ends of the lines out of the
spool.
If the spool is empty, see "Replacing
Nylon Line".
Power supply (mains) voltage and
operating voltage must be the same.
N Insert the plug (1) in the wall
outlet (2).
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using it for the first time.
N Connect the charger to the power
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger only in enclosed
and dry rooms at ambient temperatures
between +5°C to +40°C (+41°F to
+104°F)
Only charge dry batteries. Allow a damp
battery to dry before charging.
N Push the battery (1) into the
charger (2) until noticeable
resistance is felt – then push it as far
as stop.
Adjusting Nylon Line
1
2
3905BA010 KN
Connecting Charger to
Power Supply
3901BA015 KN
2
1
1
3901BA019 KN
Charging the Battery
2
3901BA009 KN