Instruction Manual

FSA 65, FSA 85
English
21
Winding line onto spool
N Use green-coded nylon line with a
diameter of 0.08 in (2.0 mm).
N Cut two 8 ft (2.5 m) lengths of nylon
line from the reel (special
accessory).
N Rotate the spool (2)
counterclockwise until the two arrow
points are in alignment.
N Push the straight end of each line
through one sleeve (5) in the
mowing head (3) until you feel a
noticeable resistance – and then
continue pushing as far as stop.
N Hold the mowing head steady.
N Rotate the spool counterclockwise
until the shortest line is about 4 in
(10 cm) long.
N If necessary, cut the longer line to a
length of about 4 in (10 cm).
The mowing head is now full.
Mounting the Mowing Head
N Slip the mowing head (6) over the
shaft (7) and engage hex recess (8)
on the external hexagon (9).
N Turn the spool (2) clockwise until
the two arrow heads line up –
secure the spool in this position.
N Insert the cap (1) in the spool (2),
press it down as far as stop and turn
it clockwise at the same time.
N Turn the cap (1) as far as stop and
tighten it down by hand.
3
5
3905BA019 KN
3
3905BA020 KN
8
6
9
3905BA021 KN
7
1
2
3905BA022 KN