Instruction Manual

0478 201 9913 D - EN
44
● Release clip.
GHE260, GHE260S:
● Connect the power cable connector to
the 5-pin mains plug on the machine.
10.3 Switching on the garden
shredder
● Connect the power cable. (Ö 10.2)
● Press the green button (1) on the switch
(illus. shows GHE 150, GHE 250,
GHE 250 S).
The garden shredder starts up.
10.4 Switching off the garden
shredder
● Press the red button (1) on the switch
(illus. shows GHE 150, GHE 250,
GHE 250 S).
The garden shredder motor is switched off
and braked automatically.
10.5 Checking rotational direction of
blade discs
● Switch on the garden shredder.
(Ö 10.3)
● Switch off the garden shredder.
(Ö 10.4)
● Press the splash guard inwards and
look at the blade disc from above
through the feed opening:
The correct rotational direction of the
blade disc is anti-clockwise.
10.6 Change rotational direction
of blade disc
The rotational direction of the blade discs
can be changed by reversing the polarity
of the phase rotation device on the mains
plug.
● Using screwdriver (U), turn phase
rotation device (1) 180° anti-clockwise
or clockwise until it engages.
10.7 Shredding
● Push the garden shredder onto firm and
level ground and set down safely.
● Put on thick gloves, safety glasses and
hearing protection.
● Open the discharge flap. (Ö 7.3)
● Connect the power cable of the garden
shredder.
● Start the garden shredder. (Ö 10.3)
● Wait until the garden shredder has
reached its maximum speed (idling
speed).
● Feed the garden shredder with
shredding material in the correct way.
(Ö 8.8)
● Switch off the garden shredder.
(Ö 10.4)
There must be no shredding
material in the machine when it is
switched on as it may be ejected.
The blade disc locking device must
always be tilted back to the stop.
(Ö 11.)
Only begin to feed the shredding
material once the motor has
reached the maximum speed (idling
speed).
Risk of injury!
Do not step into the ejection area
when switching off!
Stand to the side of the machine to
do so.
Beware of the work tools running
on for several seconds before
coming to a standstill after
switching off the motor.
10
11
Only switch off the motor when
there is no longer any shredding
material in the machine. Otherwise,
the blade disc may become blocked
when operation is resumed.
On models GHE 260 and
GHE 260 S, the rotational direction
of the blade disc must be checked
before commencing work (feeding).
Risk of injury!
Always wear safety glasses when
performing the check.
In the case of incorrect rotational
direction (clockwise) of the blade
disc, the rotational direction must
be changed on models GHE 260
and GHE 260 S.
12