Instruction Manual

53
DEFRNLITESPTNOSVFIDAPLSLSKHU EN
0478 201 9914 D - EN
* Attention!
Mains fuses of less than 16 A may
frequently trip during start-up of the
machine or when it is operating under
heavy load.
17.1 REACH
REACH is an EC Directive for the
registration, evaluation, authorisation and
restriction of chemicals.
Information on compliance with the
REACH Directive (EC) No. 1907/2006 is
available from www.stihl.com/reach.
Fault:
Motor does not start
Possible cause:
– Motor overload protection activated
– No mains voltage
– Electric cable, plug, plug connector or
switch defective
– Fuse in UK plug damaged (only applies
to machines for UK)
– Feed chute not properly closed - safety
cut-off switch actuated (safety interlock)
– Blade disc blocked
– Locking device is not reset
Remedy:
– Allow machine to cool down (Ö 8.8),
(Ö 10.7)
– Check power cable and fuse
# (Ö 10.1)
– Check cable, plug, connector and
switch and replace if necessary (by
electrician) # (Ö 10.1)
– Replace fuse # (Ö 10.1)
– Close feed chute properly and tighten
screws (Ö 11.3)
– Remove feed chute and remove
shredder deposits from the housing
(Important: disconnect the power cable)
(Ö 11.4)
– Reset locking device (Ö 11.7)
Fault:
Reduced shredding performance
Possible cause:
– Blunt blades
– Incorrectly ground blades
– Power cable too long
– Bent blade disc
Remedy:
– Replace or re-sharpen shredding
blades (Ö 11.9), (Ö 11.8)
– Sharpen blades correctly # (Ö 11.9)
– Use shorter power cable (Ö 10.1)
– Check blade disc visually #
Fault:
Branch material is not drawn in
Possible cause:
– Incorrect rotational direction of blade
disc
– Blunt or incorrectly ground blades
Remedy:
– Change rotational direction of blade
disc (Ö 10.7)
– Regrind combination blade and ensure
sharpening angle is exactly correct 
# (Ö 11.9)
Fault:
Feed chute cannot be fitted
Possible cause:
– Locking device is not released
Remedy:
– Release locking device (Ö 11.7)
Sound pressure level
at workplace L
pA
94 dB(A)
Uncertainty K
pA
3 dB(A)
Weight 30 kg
29 kg (CH)
32 kg (GB)
GHE 375.0:
Motor, design Electric motor
(~3)
Manufacturer ATB
Type BSRF 0.75/2-C
Voltage 400 V~
Power input 3000 W
Fuse* 10 A
Maximum branch
diameter 40 mm
Nominal motor speed 2810 rpm
Measurement in accordance with EN
50434:
Sound pressure level
at workplace L
pA
95 dB(A)
Uncertainty K
pA
3 dB(A)
Weight 31 kg
GHE 355.0:
18. Troubleshooting
# If necessary, contact a specialist
dealer; STIHL recommends STIHL
specialist dealers.