Instruction Manual

HL 94, HL 94 K
English
23
is released: The ignition is switched on
again after the engine stops – the engine
is then ready to start.
Function of Throttle Set Wheel
The throttle set wheel (4) enables the
travel of the throttle trigger to be preset
anywhere between idle and full throttle.
– Turn throttle set wheel (4) in
direction of – to reduce throttle
trigger travel and maximum engine
speed.
– Turn throttle set wheel (4) in
direction of + to increase throttle
trigger travel and maximum engine
speed.
– It is possible to override the preset
stop and open the throttle wide by
pulling the throttle trigger firmly – the
preset stop remains unaffected. The
original setting is restored when the
throttle trigger is released.
Starting the Engine
N Press the manual fuel pump
bulb (5) at least five times – even if
the bulb is already filled with fuel.
Cold engine (cold start)
N Turn choke knob (6) and then push
it in at g
Also use this setting if the engine has
been running but is still cold.
– Turn throttle set wheel in direction of
+ as far as stop.
Hot engine (hot start)
N Choke knob (6) remains in F
position.
Cranking
N Place the unit on the ground: It must
rest securely on the engine support
and the gearbox housing.
N On units with an adjustable cutter
bar and defined transport position:
Set the cutter bar to the straight (0°)
position.
N If fitted: Remove blade scabbard
from the cutting blades.
To reduce the risk of accidents, check
that the cutting blades are not touching
the ground of any other obstacles.
N Make sure you have a firm footing,
either standing, stooping or
kneeling.
N Hold the unit firmly on the ground
with your left hand and press down
– do not touch the throttle trigger,
lockout lever or stop switch.
NOTICE
Do not stand or kneel on the shaft.
0208BA067 KN
4
5
0000-GXX-5224-A0
2.
1.
6
0000-GXX-5475-A0
1191BA014 KN