Instruction Manual

0458-816-8321-A
18
English 15 Cleaning
Mounting the wall bracket
► Check the following points when mounting the wall
bracket on a wall:
– Suitable fixing materials.
– Wall bracket is horizontal.
– The following dimensions are observed:
– a = at least 20 cm
– b = at least 130 cm
– c = 22.8 cm
Fitting hedge trimmer on the wall bracket
► Switch off the hedge trimmer and remove the battery.
► Fit the blade scabbard so that it completely covers the
cutting blades.
► Disassemble the hedge trimmer.
► Hang up the shaft with the coupling sleeve.
► Hang up the cutter bar with the swivel handle.
15.1 Cleaning the Hedge Trimmer
► Switch off the hedge trimmer and remove the battery.
► Clean cooling air slots with a soft brush.
► Clean the hedge trimmer with a damp cloth or STIHL resin
solvent.
15.2 Cleaning the Cutting Blades
► Switch off the hedge trimmer and remove the battery.
► Spray both sides of blades with STIHL resin solvent.
► Fit the battery.
► Switch on the hedge trimmer for 5 seconds.
The cutting blades run. STIHL resin solvent is distributed
evenly.
15.3 Cleaning the Battery
► Clean the battery with a damp cloth.
16.1 Sharpening the Cutting Blades
STIHL recommends you have the cutting blades
resharpened by a STIHL servicing dealer.
WARNING
The teeth of the cutting blades are very sharp. There is a risk
of cut injuries.
► Wear work gloves made of durable material.
► Switch off the hedge trimmer and remove the battery.
15 Cleaning
c
a
b
0000-GXX-7609-A0
16 Maintenance
0000-GXX-8186-A0