Instruction Manual
Table Of Contents
- STIHL HLA 66, 86
- 1 Vorwort
- 2 Informationen zu dieser Gebrauchsanleitung
- 3 Übersicht
- 4 Sicherheitshinweise
- 5 Heckenschneider einsatzbereit machen
- 6 Akku laden und LEDs
- 7 Heckenschneider zusammenbauen
- 8 Akku einsetzen und herausnehmen
- 9 Heckenschneider einschalten und ausschalten
- 10 Heckenschneider und Akku prüfen
- 11 Mit dem Heckenschneider arbeiten
- 12 Nach dem Arbeiten
- 13 Transportieren
- 14 Aufbewahren
- 15 Reinigen
- 16 Warten
- 17 Reparieren
- 18 Störungen beheben
- 19 Technische Daten
- 20 Kombinationen aus Tragsystemen
- 21 Ersatzteile und Zubehör
- 22 Entsorgen
- 23 EU-Konformitätserklärung
- 24 Anschriften
- 25 Allgemeine Sicherheitshinweise für Elektrowerkzeuge
- 25.1 Einleitung
- 25.2 Arbeitsplatzsicherheit
- 25.3 Elektrische Sicherheit
- 25.4 Sicherheit von Personen
- 25.5 Verwendung und Behandlung des Elektrowerkzeugs
- 25.6 Verwendung und Behandlung des Akkuwerkzeugs
- 25.7 Service
- 25.8 Sicherheitshinweise für Heckenscheren
- 25.9 Zusätzliche Sicherheitshinweise für Heckenscheren mit verlängerter Reichweite
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing Hedge Trimmer for Operation
- 6 Charging the Battery, LEDs
- 7 Assembling the Hedge Trimmer
- 8 Removing and Fitting the Battery
- 9 Switching the Hedge Trimmer On/Off
- 10 Testing the Hedge Trimmer and Battery
- 11 Operating the Hedge Trimmer
- 12 After Finishing Work
- 13 Transporting
- 14 Storing
- 15 Cleaning
- 16 Maintenance
- 17 Repairing
- 18 Troubleshooting
- 19 Specifications
- 20 Combinations of Carrying Systems
- 21 Spare Parts and Accessories
- 22 Disposal
- 23 EC Declaration of Conformity
- 24 General Power Tool Safety Warnings
- 1 Préface
- 2 Informations concernant la présente Notice d'emploi
- 3 Vue d'ensemble
- 4 Prescriptions de sécurité
- 5 Préparatifs avant l'utilisation du coupe-haies
- 6 Recharge de la batterie et DEL
- 7 Assemblage du coupe-haies
- 8 Introduction et extraction de la batterie
- 9 Mise en marche et arrêt du coupe-haies
- 10 Contrôle du coupe-haies et de la batterie
- 11 Travail avec le coupe-haies
- 12 Après le travail
- 13 Transport
- 14 Rangement
- 15 Nettoyage
- 16 Maintenance
- 17 Réparation
- 18 Dépannage
- 19 Caractéristiques techniques
- 20 Combinaisons de systèmes de portage
- 21 Pièces de rechange et accessoires
- 22 Mise au rebut
- 23 Déclaration de conformité UE
- 24 Indications générales de sécurité pour outils électroportatifs
- 24.1 Introduction
- 24.2 Sécurité à l'endroit de travail
- 24.3 Sécurité sur le plan électrique
- 24.4 Sécurité des personnes
- 24.5 Utilisation et emploi soigneux d'outils électroportatifs
- 24.6 Utilisation et emploi soigneux d'outils électroportatifs sans fil
- 24.7 Service après-vente
- 24.8 Consignes de sécurité applicables aux taille-haies
- 24.9 Consignes de sécurité supplémentaires applicables aux taille-haies télescopiques
- 1 Premessa
- 2 Informazioni sulle presenti Istruzioni d’uso
- 3 Sommario
- 4 Avvertenze di sicurezza
- 5 Preparare il tosasiepi
- 6 Carica della batteria e LED
- 7 Assemblare il tosasiepi
- 8 Inserire e togliere la batteria
- 9 Accendere e spegnere il tosasiepi
- 10 Controllare tosasiepi e batteria
- 11 Lavorare con il tosasiepi
- 12 Dopo il lavoro
- 13 Trasporto
- 14 Conservazione
- 15 Pulizia
- 16 Manutenzione
- 17 Riparazione
- 18 Eliminazione dei guasti
- 19 Dati tecnici
- 20 Combinazioni di sistemi di trasporto
- 21 Ricambi e accessori
- 22 Smaltimento
- 23 Dichiarazione di conformità UE
- 24 Avvertenze di sicurezza generali per attrezzi elettrici
- 24.1 Introduzione
- 24.2 Sicurezza sul posto di lavoro
- 24.3 Sicurezza elettrica
- 24.4 Sicurezza delle persone
- 24.5 Impiego e maneggio dell’attrezzo elettrico
- 24.6 Impiego e trattamento dell’attrezzo a batteria
- 24.7 Assistenza
- 24.8 Avvertenze di sicurezza per tagliasiepi
- 24.9 Avvertenze di sicurezza per tagliasiepi aggiuntive per tagliasiepi con portata maggiorata
- 1 Voorwoord
- 2 Informatie met betrekking tot deze handleiding
- 3 Overzicht
- 4 Veiligheidsinstructies
- 5 Heggensnoeier klaar maken voor gebruik
- 6 Accu laden en leds
- 7 Heggensnoeier monteren
- 8 Accu aanbrengen en wegnemen
- 9 Heggensnoeier inschakelen en uitschakelen
- 10 Heggensnoeier en accu controleren
- 11 Met de heggensnoeier werken
- 12 Na de werkzaamheden
- 13 Vervoeren
- 14 Opslaan
- 15 Reinigen
- 16 Onderhoud
- 17 Repareren
- 18 Storingen opheffen
- 19 Technische gegevens
- 20 Combinaties van draagsystemen
- 21 Onderdelen en toebehoren
- 22 Milieuverantwoord afvoeren
- 23 EU-conformiteitsverklaring
- 24 Algemene veiligheidswaarschuwingen voor elektrische gereedschappen
- 24.1 Inleiding
- 24.2 Veiligheid op de werkplek
- 24.3 Elektrische veiligheid
- 24.4 Veiligheid van personen
- 24.5 Gebruik en behandeling van het elektrische gereedschap
- 24.6 Gebruik en behandeling van het accugereedschap
- 24.7 Service
- 24.8 Veiligheidsinstructies voor heggenscharen
- 24.9 Aanvullende veiligheidsinstructies voor heggenscharen op steel
to push the release slide in the direction of the
cutting blades.
If the trigger (2) and the Ergo lever (3) are
released, the trigger (2) is locked. The release
slide (1) must be pushed towards the cutting
blades again and held to unlock the trigger (2).
9.2 Switching Off
► Release the trigger and Ergo lever
► Wait until the cutting blades come to a com‐
plete standstill after about 1 second.
► If the cutting blades continue to run after about
1 second: Remove the battery and contact
your STIHL dealer for assistance.
There is a malfunction in the hedge trimmer.
10 Testing the Hedge Trimmer
and Battery
10.1 Checking the controls
Release slide, Ergo lever and trigger
► Remove the battery.
► Try squeezing the trigger switch without acti‐
vating the release slide.
► If the trigger can be pulled: Do not use the
long-reach hedge trimmer and contact your
STIHL dealer for assistance.
The release slide is faulty.
► Push the release slide in the direction of the
cutting blades with your thumb and hold it
there.
► Press and hold Ergo lever.
► Press the trigger.
The release slide can be released.
► Release the trigger and the Ergo lever.
► If the release slide, trigger or the Ergo lever is
stiff or does not spring back to the idle posi‐
tion: Do not use the long-reach hedge trimmer
and contact your STIHL dealer for assistance.
The release slide, trigger or the Ergo lever is
defective.
Switching on the long-reach hedge trimmer
► Insert battery.
► Push the release slide in the direction of the
cutting blades and hold it there.
► Press and hold the trigger.
The cutting blades run.
► If 3 LEDs flash red: Remove the battery and
consult a STIHL dealer.
There is a malfunction in the long-reach hedge
trimmer.
► Release the trigger.
The cutting blades stop running after about 1
second.
► If the cutting blades continue to run after about
1 second: Remove the battery and contact
your STIHL dealer for assistance.
There is a malfunction in the long-reach hedge
trimmer.
10.2 Testing the Battery
► Press button on battery.
The LEDs glow or flash.
► If the LEDs do not glow or flash: Do not use
the battery and contact your STIHL servicing
dealer.
There is a malfunction in the battery.
11 Operating the Hedge Trim‐
mer
11.1 Adjusting the Angle of the Cut‐
ting Blades
The angle of the cutting blades can be adjusted
to 2 different positions upwards and 3 different
positions downwards to suit the application and
the height and reach of the user.
► Switch off the long-reach hedge trimmer and
remove the battery.
1
2
45°
70°
0000-GXX-4572-A0
► Pull back the sliding sleeve (1) and hold it
there.
► Grip the swivel handle (2) and swing cutting
blade to required angle.
► Release the sliding sleeve (1).
► Move swivel handle (2) back and forth until the
sliding sleeve (1) engages.
The sliding sleeve (1) butts against the hous‐
ing. You have adjusted the angle of the cutting
blades.
► Check that the swivel handle (2) cannot be
pushed in or pulled out any more.
11.2 Adjusting the Shaft Length
(HLA 86)
The shaft can be adjusted to different lengths to
suit the application as well as the user's height
and reach.
► Switch off the long-reach hedge trimmer and
remove the battery.
English 10 Testing the Hedge Trimmer and Battery
32 0458-185-9621-B