Operation Manual

0458-765-9921-C
44
English 8 Adjusting Hedge Trimmer for User
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the drive tube
(5).
► Fit washers (2) on the screws (1).
► Hold the clamp (6) against the drive tube (5).
► Insert screws (1) through holes in loop handle (3) and
clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
8.1 Fitting and Adjusting the Carrying System
► Switch off the hedge trimmer, push retaining latch to
position and remove the battery.
► Put on the shoulder strap (1) or full harness (3).
► Adjust the shoulder strap (1) or full harness (3) so that the
carabiner (2) is about a hand’s width below your right hip.
► Connect the carrying ring (3) to the carabiner (2).
8.2 Adjusting Length of Shaft
HLA 85
The shaft can be adjusted to different lengths to suit the
application and height and reach of the user.
► Switch off the hedge trimmer, push retaining latch to
position and remove the battery.
► Open the lever (1) of the quick release clamp (2).
► Adjust shaft (3) to the required length.
► Close the lever (1) of the quick release clamp (2).
The shaft (3) is now fixed in position.
8 Adjusting Hedge Trimmer for User
1
3
4
5
2
1
2
6
7
0000-GXX-4561-A0
1 3
2
2
0000-GXX-4594-A0
1
2
3
0000-GXX-4562-A0
180°
3
2
1
0000-GXX-4565-A0