Operation Manual
0458-765-9921-C
49
English
13 After Finishing Work
► Set the cutter bar to a suitable angle.
► Hold the cutting blades at an angle of 0° to 10° to the top
of the hedge.
► Swing the hedge trimmer horizontally and in an arc while
making the cut.
► If cutting performance deteriorates: Sharpen the cutting
blades.
13.1 After Finishing Work
► Switch off the hedge trimmer, push retaining latch to
position and remove the battery.
► If the hedge trimmer is wet: Allow the hedge trimmer to
dry.
► Clean the hedge trimmer.
► Clean the cutting blades.
► Fit the blade scabbard so that it completely covers the
cutting blades.
► Clean the battery.
14.1 Transporting the Hedge Trimmer
► Switch off the hedge trimmer, push retaining latch to
position and remove the battery.
► Fit the blade scabbard so that it completely covers the
cutting blades.
► Pull the sliding sleeve (4) back and hold it there.
► Grip the swivel handle (3) and swing the cutting blades (1)
against the shaft.
Cutting blades (1) are flat against the shaft (2).
► Release the sliding sleeve (4).
The sliding sleeve (4) engages in position and butts
against the housing. Cutting blades (1) are in the transport
position.
► Carry the hedge trimmer by the shaft with the cutting
blades (1) behind you.
► Transporting the hedge trimmer in a vehicle: Secure the
hedge trimmer to prevent it turning over or shifting.
14.2 Transporting the Battery
► Switch off the hedge trimmer, push retaining latch to
position and remove the battery.
► Make sure the battery is in a safe condition.
► Observe the following points when packing the battery:
13 After Finishing Work
0000-GXX-4576-A0
14 Transporting
4
2
3
1
0000-GXX-4577-A0