Instruction Manual
Table Of Contents
- STIHL HLA 66, 86
- 1 Vorwort
- 2 Informationen zu dieser Gebrauchsanleitung
- 3 Übersicht
- 4 Sicherheitshinweise
- 5 Heckenschneider einsatzbereit machen
- 6 Akku laden und LEDs
- 7 Heckenschneider zusammenbauen
- 8 Akku einsetzen und herausnehmen
- 9 Heckenschneider einschalten und ausschalten
- 10 Heckenschneider und Akku prüfen
- 11 Mit dem Heckenschneider arbeiten
- 12 Nach dem Arbeiten
- 13 Transportieren
- 14 Aufbewahren
- 15 Reinigen
- 16 Warten
- 17 Reparieren
- 18 Störungen beheben
- 19 Technische Daten
- 20 Kombinationen aus Tragsystemen
- 21 Ersatzteile und Zubehör
- 22 Entsorgen
- 23 EU-Konformitätserklärung
- 24 Anschriften
- 25 Allgemeine Sicherheitshinweise für Elektrowerkzeuge
- 25.1 Einleitung
- 25.2 Arbeitsplatzsicherheit
- 25.3 Elektrische Sicherheit
- 25.4 Sicherheit von Personen
- 25.5 Verwendung und Behandlung des Elektrowerkzeugs
- 25.6 Verwendung und Behandlung des Akkuwerkzeugs
- 25.7 Service
- 25.8 Sicherheitshinweise für Heckenscheren
- 25.9 Zusätzliche Sicherheitshinweise für Heckenscheren mit verlängerter Reichweite
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing Hedge Trimmer for Operation
- 6 Charging the Battery, LEDs
- 7 Assembling the Hedge Trimmer
- 8 Removing and Fitting the Battery
- 9 Switching the Hedge Trimmer On/Off
- 10 Testing the Hedge Trimmer and Battery
- 11 Operating the Hedge Trimmer
- 12 After Finishing Work
- 13 Transporting
- 14 Storing
- 15 Cleaning
- 16 Maintenance
- 17 Repairing
- 18 Troubleshooting
- 19 Specifications
- 20 Combinations of Carrying Systems
- 21 Spare Parts and Accessories
- 22 Disposal
- 23 EC Declaration of Conformity
- 24 General Power Tool Safety Warnings
- 1 Préface
- 2 Informations concernant la présente Notice d'emploi
- 3 Vue d'ensemble
- 4 Prescriptions de sécurité
- 5 Préparatifs avant l'utilisation du coupe-haies
- 6 Recharge de la batterie et DEL
- 7 Assemblage du coupe-haies
- 8 Introduction et extraction de la batterie
- 9 Mise en marche et arrêt du coupe-haies
- 10 Contrôle du coupe-haies et de la batterie
- 11 Travail avec le coupe-haies
- 12 Après le travail
- 13 Transport
- 14 Rangement
- 15 Nettoyage
- 16 Maintenance
- 17 Réparation
- 18 Dépannage
- 19 Caractéristiques techniques
- 20 Combinaisons de systèmes de portage
- 21 Pièces de rechange et accessoires
- 22 Mise au rebut
- 23 Déclaration de conformité UE
- 24 Indications générales de sécurité pour outils électroportatifs
- 24.1 Introduction
- 24.2 Sécurité à l'endroit de travail
- 24.3 Sécurité sur le plan électrique
- 24.4 Sécurité des personnes
- 24.5 Utilisation et emploi soigneux d'outils électroportatifs
- 24.6 Utilisation et emploi soigneux d'outils électroportatifs sans fil
- 24.7 Service après-vente
- 24.8 Consignes de sécurité applicables aux taille-haies
- 24.9 Consignes de sécurité supplémentaires applicables aux taille-haies télescopiques
- 1 Premessa
- 2 Informazioni sulle presenti Istruzioni d’uso
- 3 Sommario
- 4 Avvertenze di sicurezza
- 5 Preparare il tosasiepi
- 6 Carica della batteria e LED
- 7 Assemblare il tosasiepi
- 8 Inserire e togliere la batteria
- 9 Accendere e spegnere il tosasiepi
- 10 Controllare tosasiepi e batteria
- 11 Lavorare con il tosasiepi
- 12 Dopo il lavoro
- 13 Trasporto
- 14 Conservazione
- 15 Pulizia
- 16 Manutenzione
- 17 Riparazione
- 18 Eliminazione dei guasti
- 19 Dati tecnici
- 20 Combinazioni di sistemi di trasporto
- 21 Ricambi e accessori
- 22 Smaltimento
- 23 Dichiarazione di conformità UE
- 24 Avvertenze di sicurezza generali per attrezzi elettrici
- 24.1 Introduzione
- 24.2 Sicurezza sul posto di lavoro
- 24.3 Sicurezza elettrica
- 24.4 Sicurezza delle persone
- 24.5 Impiego e maneggio dell’attrezzo elettrico
- 24.6 Impiego e trattamento dell’attrezzo a batteria
- 24.7 Assistenza
- 24.8 Avvertenze di sicurezza per tagliasiepi
- 24.9 Avvertenze di sicurezza per tagliasiepi aggiuntive per tagliasiepi con portata maggiorata
- 1 Voorwoord
- 2 Informatie met betrekking tot deze handleiding
- 3 Overzicht
- 4 Veiligheidsinstructies
- 5 Heggensnoeier klaar maken voor gebruik
- 6 Accu laden en leds
- 7 Heggensnoeier monteren
- 8 Accu aanbrengen en wegnemen
- 9 Heggensnoeier inschakelen en uitschakelen
- 10 Heggensnoeier en accu controleren
- 11 Met de heggensnoeier werken
- 12 Na de werkzaamheden
- 13 Vervoeren
- 14 Opslaan
- 15 Reinigen
- 16 Onderhoud
- 17 Repareren
- 18 Storingen opheffen
- 19 Technische gegevens
- 20 Combinaties van draagsystemen
- 21 Onderdelen en toebehoren
- 22 Milieuverantwoord afvoeren
- 23 EU-conformiteitsverklaring
- 24 Algemene veiligheidswaarschuwingen voor elektrische gereedschappen
- 24.1 Inleiding
- 24.2 Veiligheid op de werkplek
- 24.3 Elektrische veiligheid
- 24.4 Veiligheid van personen
- 24.5 Gebruik en behandeling van het elektrische gereedschap
- 24.6 Gebruik en behandeling van het accugereedschap
- 24.7 Service
- 24.8 Veiligheidsinstructies voor heggenscharen
- 24.9 Aanvullende veiligheidsinstructies voor heggenscharen op steel
Carrying the long-reach hedge trimmer
4
2
3
1
0000097083_001
► Pull back the sliding sleeve (4) and hold it
there.
► Grip the swivel handle (3) and swing the cut‐
ting blades (1) against the shaft.
The cutting blades (1) are flat against the shaft
(2).
► Release the sliding sleeve (4).
The sliding sleeve (4) engages in position and
butts against the housing. The cutting blades
(1) are in the transport position.
► Carry the long-reach hedge trimmer by the
shaft with the cutting blades (1) behind you.
Transporting the long-reach hedge trimmer in a
vehicle
► Secure the long-reach hedge trimmer so that it
cannot turn over or move.
13.2 Transporting the Battery
► Switch off the hedge trimmer and remove the
battery.
► Make sure the battery is in a safe condition.
► Observe the following points when packing the
battery:
–
The packaging must be non-conductive.
–
Make sure the battery cannot shift inside the
packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the requirements for the
transport of dangerous goods. The battery is
classified as UN 3480 (lithium-ion batteries) and
has been tested in accordance with UN Manual
of Tests and Criteria, Part III, sub-section 38.3.
For transport regulations see www.stihl.com/
safety-data-sheets
14 Storing
14.1 Storing the Hedge Trimmer
► Switch off the hedge trimmer and remove the
battery.
► Fit the blade scabbard so that it completely
covers the cutting blades.
► Observe the following points when storing the
hedge trimmer:
–
Hedge trimmer is out of the reach of chil‐
dren.
–
Hedge trimmer is clean and dry.
14.2 Storing the Battery
STIHL recommends that you store the battery
with a charge between 40% and 60% (2 LEDs
glow green).
► Observe the following points when storing the
battery:
–
Battery is out of the reach of children.
–
Battery is clean and dry.
–
Battery is in an enclosed location.
–
Battery is stored separately from the hedge
trimmer and charger.
–
Battery is in non-conductive packaging.
–
Battery is in a temperature range between
-10°C and +50°C.
15 Cleaning
15.1 Cleaning the long-reach hedge
trimmer
► Switch off the long-reach hedge trimmer and
remove the battery.
► Clean the long-reach hedge trimmer with a
damp cloth or STIHL resin solvent.
► Clean vents with a paintbrush.
► Remove foreign objects from the battery com‐
partment and clean the battery compartment
with a damp cloth.
► Clean the electrical contacts in the battery
compartment with a paintbrush or soft brush.
15.2 Cleaning the Cutting Blades
► Switch off the hedge trimmer and remove the
battery.
► Spray both sides of blades with STIHL resin
solvent.
► Fit the battery.
► Switch on the hedge trimmer for 5 seconds.
The cutting blades run. STIHL resin solvent is
distributed evenly.
15.3 Cleaning the Battery
► Clean the battery with a damp cloth.
16 Maintenance
16.1 Maintenance intervals
Maintenance intervals depend on the ambient
conditions and the operating conditions. STIHL
recommends the following maintenance inter‐
vals:
14 Storing
English
0458-185-9621-B 35