Instruction Manual

HS 82 R, HS 82 T
English
20
As Soon As the Engine Runs
N Press down the throttle trigger
lockout and open the throttle – the
choke knob moves to the run
position e. After a cold start, warm
up the engine by opening the
throttle several times.
WARNING
Make sure the carburetor is correctly
adjusted. The cutting attachment must
not run when the engine is idling.
Your machine is now ready for
operation.
Stopping the Engine
N Move the stop switch in the direction
of 0 – when released, the stop
switch springs back to the normal
run position I.
Other Hints on Starting
At very low outside temperatures –
warm up the engine
As soon as the engine runs:
N Allow engine to run in starting
throttle position for about 10
seconds.
N Open the throttle wide – the slide
control springs back to the normal
run position e and the engine
returns to idling speed.
Engine does not start in warm start
position f
N Move the choke knob to g and
continue cranking until the engine
runs.
If the engine does not start
N Check that all settings are correct.
N Check that there is fuel in the tank
and refuel if necessary.
N Check that the spark plug boot is
properly connected.
N Repeat the starting procedure.
Engine is flooded
N Depress the outer ring of the choke
knob and then turn it to e –
continue cranking until engine runs.
Fuel tank run until completely dry
N After refueling, depress the manual
fuel pump bulb at least 5 times –
even if the bulb is already filled with
fuel.
N Set the choke lever to suit the
engine temperature.
N Now start the engine.
0000-GXX-1807-A0
0000-GXX-1808-A0