Instruction Manual

HS 82 R, HS 82 T
English
23
WARNING
To reduce the risk of fire caused by hot
particles escaping from the machine,
never operate the machine without a
spark arresting screen, or with the spark
arresting screen damaged. Do not
modify the muffler or spark arresting
screen.
NOTICE
According to the law or regulations in
some countries or federal states, certain
operations may only be carried out if a
properly serviced spark arresting screen
is provided.
N Check the spark arresting screen in
the muffler after every 20 hours of
operation, or if the engine is down
on power or runs erratically at
maximum speed.
WARNING
Wait for the engine to cool down
completely before performing this work.
N Take out the screws (1).
N Remove the exhaust pipe (2).
N Use a 16 mm socket wrench to
unscrew the spark arresting
screen (3).
N Clean the spark arresting screen. If
the screen is damaged or heavily
carbonized, fit a new one.
N Refit the spark arresting screen.
N Fit the exhaust pipe.
N Fit the screws.
If there is a loss of engine power, the
machine is difficult to start or runs poorly
at idle, first check the spark plug.
Install a new spark plug after
approximately 100 operating hours or
earlier if the electrodes are
eroded/corroded.
The wrong fuel mix (too much engine oil
in the gasoline), a dirty air filter and
unfavorable running conditions (mostly
at part throttle etc.) affect the condition
of the spark plug. These factors cause
deposits to form on the insulator nose,
which may degrade performance.
Removing the Spark Plug
N Pull off the spark plug boot.
N Unscrew the spark plug.
Spark Arresting Screen in
Muffler
0000-GXX-7196-A0
2
0000-GXX-6547-A0
3
0000-GXX-6548-A0
Spark Plug
0000-GXX-1819-A0