Owner's Manual

HSA 65
English
12
Horizontal cut
Hold the cutting blade at an angle of 0°
to 10° as you swing the hedge trimmer
horizontally, using both sides of the
blade.
Swing the cutting blade in an arc
towards the outside of the hedge so that
the cuttings are swept to the ground.
Repeat the procedure several times on
wide hedges.
Mains voltage and operating voltage
must be the same.
N Insert the mains plug (1) in the wall
outlet (2).
A self test is performed after the charger
is connected to the power supply. During
this process the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
The battery is given a charge of about
30% before leaving the factory.
It must be fully charged before you use
the power tool for the first time.
N Connect the charger to the power
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger only in enclosed
and dry rooms at ambient temperatures
between 41°F (5°C) and 104°F (40°C).
N Push the battery (1) into the
charger (2) until you feel noticeable
resistance – then push it as far as
stop.
3901BA025 KN
3901BA006 KN
Connecting Charger to
Power Supply
3901BA015 KN
2
1
1
3901BA019 KN
Charging the Battery
2
3901BA009 KN