Owner's Manual

HSA 65
English
24
Running time is too short
Battery is not fully charged Charge the battery
Life of battery has been reached or
exceeded
Check battery
1)
and replace
Blades sticking / dirty Clean the blades and spray them with
STIHL resin solvent
Battery jams when being inserted in power
tool / charger
Guides dirty Carefully clean the guides
Battery is not charging even though the light
emitting diode on the charger lights up green
Battery too hot / too cold
(1 light emitting diode on battery lights
up red)
Allow battery to cool down / Warm up
battery slowly at a temperature of 60°F
to 70°F (15°C–20°C).
Operate the charger only in enclosed
and dry rooms at ambient temperatures
between 40°F (5°C) and 105°F (5°C–
40°C).
Light emitting diode on charger flashes red
No electrical contact between charger
and battery
Remove the battery and refit it properly
Battery faulty
(4 light emitting diodes on battery flash
red for about 5 seconds)
Install new battery
1)
Charger faulty Have charger checked by servicing
dealer
1)
1)
STIHL recommends a STIHL servicing dealer.
Always remove the battery before carrying out any work on the power tool.
Condition Cause Remedy