Owner's Manual

HSA 66
English
15
A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using it for the first time.
N If necessary, remove the cover from
the battery compartment before
fitting the battery, i.e. depress both
locking tabs to unlock and remove
the cover.
Fitting the Battery
N Insert the battery (1) in the power
tool – the battery slides into the
compartment – press it down
carefully until it snaps into position –
the battery must be flush with the
top of the housing.
Switching on the Machine
N Make sure you have a secure and
firm footing.
N Stand upright – hold the power tool
in a relaxed position.
N Make sure the cutting attachment is
not touching the ground or any other
objects.
N Hold the power tool with both hands
– one hand on the control handle –
one hand on the loop handle.
N Unlock the power tool by moving the
retaining latch (2) to ‚.
N Push the switch lever (3) against
the loop handle and hold it there.
N Push down the trigger switch
lockout (4) and depress the trigger
switch (5) and hold them in that
position.
The motor runs only if the retaining
latch (2) is on ‚ and the switch
lever (3) and trigger switch (5) are
operated simultaneously.
Trigger
Motor speed can be controlled with the
trigger switch. Depress the trigger switch
to accelerate the motor.
Switching On
3901BA028 KN
1
3901BA029 KN
2
4
3
5
9938BA005 KN