Instruction Manual

HT 100, HT 101, HT 130, HT 131
English
16
30° angle drive (special accessory)
The angle drive keeps the cutting
attachment at an angle of 30° to the
drive tube.
The angle drive may be adjusted on the
drive tube to the following positions only:
1 For cross-cutting vertical branches
and bushes.
2 For a better view of the cutting
attachment.
Removing the chain sprocket cover
N Unscrew the nut and remove the
cover.
N Turn the screw (1)
counterclockwise until the tensioner
slide (2) butts against the left end of
the housing slot, then back it off 5
full turns.
Fitting the chain
N Fit the chain – start at the bar nose.
1
2
390BA053 KN
Mounting the Bar and
Chain
390BA042 KN
1
2
390BA043 KN
Wear work gloves to protect your
hands from the sharp cutters.
390BA003 KN