Instruction Manual

HT 100, HT 101, HT 130, HT 131
English
45
Cutting attachments
Rollomatic E Mini guide bar
Actual cutting length will be less than
listed bar length.
Rollomatic E Mini Light guide bars
Actual cutting length will be less than
listed bar length.
Saw chain 3/8" P
Chain sprocket
Since new bar/chain combinations may
be developed after publication of this
Manual, ask your STIHL dealer for the
latest STIHL recommendations.
Users of this unit should carry out only
the maintenance operations described
in this manual. STIHL recommends that
other repair work be performed only by
authorized STIHL servicing dealers.
Warranty claims following repairs can be
accepted only if the repair has been
performed by an authorized STIHL
servicing dealer using genuine STIHL
replacement parts.
Genuine STIHL parts can be identified
by the STIHL part number, the
{ logo and, in some cases, by
the STIHL parts symbol K. The
symbol may appear alone on small
parts.
Observe all country-specific waste
disposal rules and regulations.
STIHL products must not be thrown in
the garbage can. Take the product,
accessories and packaging to an
approved disposal site for environment-
friendly recycling.
Contact your STIHL servicing dealer for
the latest information on waste disposal.
Reduced kickback STIHL guide bars
(with green label)
Bar lengths: 30 cm (12 in.)
Pitch: 3/8" P (9.32 mm)
Groove width: 1.1 mm (0.043 in.)
Reduced kickback STIHL guide bars
(with green label)
Bar lengths: 25, 30 cm (10, 12 in.)
Pitch: 3/8" P (9.32 mm)
Groove width: 1.1 mm (0.043 in.)
Low kickback STIHL saw chain (with
green label)
Picco Micro Mini 3 (61 PMM3)
Type 3610
Pitch: 3/8" P (9.32 mm)
Drive link gauge: 1.1 mm (0.043 in.)
6-tooth for 3/8" P
7-tooth for 3/8" P
Maintenance and Repairs Disposal
000BA073 KN