Instruction Manual

HT 102, HT 103, HT 132, HT 133
English
12
N Shut off the engine.
N Wear work gloves to protect your
hands.
N The chain must fit snugly against
the underside of the bar and it must
still be possible to pull the chain
along the bar by hand.
N If necessary, re-tension the chain.
A new chain has to be re-tensioned
more often than one that has been in
use for some time.
N Check chain tension frequently –
see chapter on "Operating
Instructions".
It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
assembled.
N Set the throttle trigger to the full
throttle position.
N Carefully rotate the screw in the
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another half turn in the
same direction.
Clip-On Carrying Ring (only versions
with telescoping shaft)
Position of carrying ring
Depending on the shaft length, the
following positions are recommended:
– Telescoping shaft compressed,
distance A = 15 cm (6 in)
– Telescoping shaft fully extended,
distance B = 50 cm (20 in)
Fitting the clip-on carrying ring
N Squeeze the ends (arrows) together
and push carrying ring onto the
shaft.
Checking Chain Tension
246BA025 KN
Adjusting the Throttle Cable
002BA655 KN
Fitting the Clip
A
B
0000-GXX-1673-A0
0000-GXX-1672-A0