Instruction Manual

HTA 65, HTA 85
English
31
Storing the Battery
N Take the battery out of the power
tool or the charger.
N Store indoors in a dry and safe
location. Keep out of the reach of
children and other unauthorized
persons and protected from
contamination.
N Do not store spare batteries unused
– use in rotation.
To optimize the life of the battery, store
it at a state of charge of about 30%.
Storing the Charger
N Remove the battery.
N Disconnect the plug from the wall
outlet.
N Store the charger indoors in a dry
and secure location. Keep out of the
reach of children and other
unauthorized persons and
protected from contamination.
N Move the retaining latch to ƒ.
N Remove the battery.
N Remove the chain sprocket cover,
chain and guide bar.
N Replace the chain sprocket:
– after using two saw chains;
– or sooner if the wear marks (a) on
the sprocket are deeper than
approx. 0.5 mm (0.020 in) since this
would reduce the life of the chain.
You can use a gauge (special
accessory) to check the depth of the
wear marks.
It is best to use two saw chains in
rotation with one sprocket.
N Use a screwdriver to remove the E-
clip (1).
N Pull off the chain sprocket (2).
N Push the new sprocket (2) on as far
as stop.
N Fit the E-clip (1).
Checking and Replacing the
Chain Sprocket
a
0022BA030 AS
1
2
0022BA031 AS
1
2
0022BA032 AS