Operation Manual

KM 94 R
English
15
Cranking
N Place the power tool on the ground
so that it rests on the machine
support:
N If fitted: Remove the transport guard
from the cutting attachment.
To reduce the risk of accidents, check
that the working tool is not touching the
ground or any other obstacles – see also
"Starting / Stopping the Engine" in the
KombiTool instruction manual.
N Make sure you have a firm footing,
either standing, stooping or
kneeling.
N Hold the unit firmly on the ground
with your left hand and press down
– do not touch the throttle trigger,
lockout lever or stop switch.
NOTICE
Do not stand or kneel on the drive tube.
N Hold the starter grip with your right
hand.
N Pull the starter grip slowly until you
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
N Continue cranking until engine runs.
As soon as the engine runs
At temperatures below +10 °C (+50 °F)
Warm up the engine for at least
10 seconds in position g.
At temperatures above +10 °C (+50 °F)
Warm up the engine for at least
5 seconds in position g.
N Depress throttle trigger lockout and
pull the throttle trigger – the choke
knob moves to the Run F position.
Warm up a cold engineat varying
speeds.
WARNING
Make sure the carburetor is correctly
adjusted. The working tool must not
rotate when the engine is idling.
Your machine is now ready for
operation.
Stopping the Engine
N Depress the momentary contact
stop switch – the engine stops –
release the stop switch – it springs
back to the run position.
Other Hints on Starting
Engine stalls in cold start position g.
N Depress throttle trigger lockout and
pull the throttle trigger – the choke
knob moves to the Run F position.
N Continue cranking in position F until
the engine runs.
192BA002 KN
192BA003 KN
1191BA025 KN