Instruction Manual

MM 55, MM 55 C
English
13
Controls
1 Throttle trigger lockout
2 Throttle trigger
3 Slide control
Positions of slide control
4START – ignition is switched on –
the engine can start
5 F – normal run position – the engine
is running or can start
6STOP-0 – engine off – the ignition is
switched off
Symbol on slide control
7 h – stop symbol and arrow. To stop
the engine, push the slide control in
the direction of the arrow on the stop
symbol (h) to STOP-0.
Starting
N Swing bike handle into working
position – see "Adjusting the Bike
Handle"
N Press down the trigger lockout lever
and squeeze the throttle trigger
N and hold them in that position.
N Move the slide control to START
and hold it there.
N Now release the throttle trigger,
slide control and trigger lockout in
that order. This is the starting
throttle position.
N Set the choke lever (8) to
N Press the manual fuel pump
bulb (9) at least five times – even if
the bulb is filled with fuel.
Cranking
N Retract the wheels, if fitted.
N Put the unit on the ground: It must
rest securely on the engine flange
and the support on the frame.
Check that the MultiTool is not
touching the ground or any other
Starting / Stopping the
Engine
1
4
56
7
3
START
2
STOP
002BA036 KN
8
469BA033 KN
9
g if the engine is cold
e for warm start – also use this posi-
tion if the engine has been running
but is still cold.
469BA061 AS
469BA062 AS