Instruction Manual

MM 55, MM 55 C
English
15
N Set the choke lever to e – even if
the engine is cold.
N Now start the engine.
Fuel tank run until completely dry
N After refueling, press the manual
fuel pump bulb at least five times –
even if the bulb is filled with fuel.
N Set the choke lever to suit the
engine temperature.
N Now start the engine.
To increase the weight on the MultiTool,
the MultiEngine can be retrofitted with
an additional weight (special
accessory).
Always use original STIHL additional
weight. Using other weights can lead to
damage to the machine and personal
injuries.
Attaching additional weight
No wheels are attached to the
MultiEngine
Use the combination wrench to loosen
and tighten the weights.
Detach the weights on the side without
the square – to do this:
The weights (1) on the side with the
square (2) remain mounted on the bolt.
N Unscrew the hexagon head bolt (3)
and remove the outer weight (4)
N Detach the inner weight (5) and
remove it from the bolt
N Push additional weight (1) with bolt
through the hole (6) in the flange; in
the process, rotate it until the
square (2) engages in the opening
in the flange
N Turn the inner weight (5) onto the
bolt and tighten
N Fasten outer weight (4) with the
hexagon head bolt (3) in the thread
of the inner weight and tighten
One or two weights can be mounted on
each side of the additional weight as
needed.
NOTICE
The maximum additional weight is
8.8 lbs. (4 kg). Never use higher
additional weight. This can cause
damage to the machine.
Wheels are attached to the MultiEngine
If wheels (special accessory) – see
"Wheels" – are already attached to the
MultiEngine, then additional parts are
required in order to install the additional
weight.
Extra weight
469BA053 KN
1
2
3
4
5
Weights on
each side
Additional weight,
total
1 4.4 lbs. (2 kg)
2 8.8 lbs. (4 kg)
6
469BA054 KN
1
2
3
4
5