Instruction Manual

MM 55, MM 55 C
English
17
N Loosen knob (8)
N Engage knob in the desired working
position and tighten it
During break-in period
A factory-new machine should not be
run at high revs (full throttle off load) for
the first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During Operation
After a long period of full throttle
operation, allow the engine to run for a
short while at idle speed so that engine
heat can be dissipated by the flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After Finishing Work
Storing for a short period: Wait for the
engine to cool down. Empty the fuel tank
and keep the machine in a dry place,
well away from sources of ignition, until
you need it again. For longer out-of-
service periods – see "Storing the
Machine".
If there is a noticeable loss of engine
power
N Set choke lever to g
N Remove screw (1)
N Remove filter cover (2)
N Remove coarse dirt from inside the
filter cover and around the filter
8
469BA036 KN
Operating Instructions Replacing the Air Filter
1
469BA037 KN
2