Instruction Manual

MS 170, MS 170 C, MS 180, MS 180 C
English
33
Removing the shroud
N Use a suitable tool to open the catch
by turning it 90° to the left
N Lift off the shroud
Refitting the shroud
Install parts in reverse order.
If there is a noticeable loss of engine
power
N Simultaneously press the throttle
trigger lockout and throttle trigger
and set the Master Control lever to
cold start l
N Clean away loose dirt from around
the filter
N Remove the shroud – see "Shroud"
N Pull the filter upwards to remove
N Knock out the filter or blow it clear
with compressed air from the inside
outwards - do not wash
Do not clean fleece filters with a brush!
If the filter cannot be cleaned or is
damaged, replace the filter
N Reinstall air filter
Exhaust emissions are controlled by the
design of the engine and components
(e.g. carburation, ignition, timing and
valve or port timing).
Shroud
207BA039 KN
Cleaning the Air Filter
207BA037 KN
Engine Management