Owner's Manual

MS 200 T
English
35
Replacing the starter rope
N Take out the screws (1).
N Ease the fan housing away from the
crankcase and remove it sideways.
N Use a screwdriver or suitable pliers
to remove the spring clip (2) from
the starter post.
N Carefully remove the rope rotor with
washer (3) and pawl (4).
N Pry the cap (5) out of the grip.
N Remove the remaining rope from
the rotor and grip – make sure the
sleeve is not pushed out of the grip.
N Tie a simple overhand knot in the
new rope and then thread it through
the top of the grip and the rope
bushing (6).
N Refit the cap in the grip.
N Thread the rope through the rotor
and secure it with a simple
overhand knot.
N Coat the rope rotor bearing bore
with non-resinous oil.
N Slip the rotor over the starter post –
turn it back and forth to engage the
anchor loop of the rewind spring.
N Refit the pawl (4) in the rotor.
N Fit the washer (3) on the starter
post.
N Use a screwdriver or suitable pliers
to install the spring clip (2) on the
starter post and engage it on the
pawl's peg – the spring clip must
point clockwise as shown in the
illustration.
Tensioning the rewind spring
N Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow.
N Hold the rotor steady.
N Pull out and straighten the twisted
rope.
Replacing the Starter Rope
and Rewind Spring
The rewind spring may pop out
and uncoil during this operation –
take care to avoid the risk of
injury.
1
1
1
142BA078 KN
1