Owner's Manual

MS 362 C
English
53
EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
Engine
STIHL single cylinder two-stroke engine
Ignition System
Electronic magneto ignition
Fuel System
All position diaphragm carburetor with
integral fuel pump
Chain Lubrication
Fully automatic, speed-controlled oil
pump with rotary piston. Additional
manual oil flow control
Weight
Cutting Attachment
Recommended cutting attachments
complying with Section 5.11 of ANSI B
175.1-2000.
Observe notes on ANSI B 175.1-2000
and definition of "reduced kickback
chain" in chapter on "Safety
Precautions".
3/8" chains
Rollomatic E guide bars with
sprocket nose
Other yellow-labeled chains and bars
for this powerhead:
Specifications
A = 300 hours
B = 125 hours
C = 50 hours
Displacement: 3.6 cu. in. (59 cm
3
)
Bore: 1.85 in. (47 mm)
Stroke: 1.34 in. (34 mm)
Engine power to
ISO 7293:
4.6 hp (3.4 kW) at
9,500 rpm
Idle speed: 2,800 rpm
Max. permissible
engine speed with
bar and chain: 14,000 rpm
Spark plug (resistor
type):
BoschWSR6F,
NGK BPMR 7 A
Electrode gap: 0.02 in. (0.5 mm)
Fuel tank capacity: 20.3 fl.oz (0.60 l)
Oil tank capacity: 11.0 fl.oz. (0.325 l)
dry, without bar and chain
MS362C: 13.0lbs (5.9kg)
Reduced kickback STIHL saw chains
(with green label)
Rapid Super C3 (33 RSC3)
Rapid Super C3 (36 RSC3)
Rapid Micro C3 (33 RMC3)
Rapid Micro C3 (36 RMC3)
Pitch: 3/8" (9.32 mm)
Drive link gauge: 0.050 in.
(1.3 mm)/0.063 in.
(1.6 mm)
Reduced kickback STIHL guide bar
(with green label)
Bar lengths
(3/8"):
16, 18, 20, 25 in (40, 45,
50, 63 cm)
Groove width: 0.050 in.
(1.3 mm)/0.063 in.
(1.6 mm)
STIHL saw chain (with yellow label)
Rapid Micro Comfort (33 RMC)
Rapid Micro Comfort (36 RMC)
Rapid Super Comfort (33 RSC)
Rapid Super Comfort (36 RSC)
Pitch: 3/8" (9.32 mm)
Drive link gauge: 0.050 in. (1.3
mm)/0.063 in.
(1.6 mm)