Instruction Manual

MS 441 C-M
English
26
Chain scabbard
Your saw comes standard with a chain
scabbard that matches the cutting
attachment.
If you use guide bars of different lengths
on the saw, the length of the chain
scabbard must be matched to the guide
bar to reduce the risk of injury. It should
cover the full length of the guide bar.
The length of the matching guide bars is
marked on the side of the chain
scabbard.
Chain scabbard extensions
One chain scabbard extension is
required for guide bars longer than
35.4 in (90 cm). Two extensions are
required for guide bars longer than
47.2 in (120 cm).
Depending on original equipment, the
chain scabbard extension either comes
with the machine or is available as a
special accessory.
Fitting chain scabbard extension
N Push the chain scabbard
extension (1) and chain
scabbard (2) together, making sure
the locking tabs (3) engage in the
chain scabbard
N If more than one chain scabbard
extension is required, push the
second chain scabbard extension
and the first chain scabbard
extension together, making sure the
locking tabs (3) engage in the first
chain scabbard extension
Removing the chain sprocket cover
N Unscrew the nuts and take off the
chain sprocket cover.
N Turn the screw (1)
counterclockwise until the tensioner
slide (2) butts against the left end of
the housing slot.
001BA244 KN
001BA249 KN
3
31 2
001BA250 KN
3
3
Mounting the Bar and Chain
143BA034 KN
1
2
001BA185 KN