Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 IMPORTANT SAFETY INSTRUCTIONS
- 6 Kickback and Other Reactive Forces
- 7 Proper Techniques for Pruning
- 8 Battery Safety
- 9 Maintenance, Repair and Storage
- 10 Before Starting Work
- 11 Charging the Battery
- 12 LED Diagnostics and Acoustic Signals
- 13 STIHL AR Backpack Battery
- 14 Assembling the Chain Saw
- 15 The Chain Brake
- 16 Inserting and Removing the Battery
- 17 Switching the Chain Saw On and Off
- 18 Checking the Chain Saw
- 19 After Finishing Work
- 20 Transporting the Chain Saw and Battery
- 21 Storing the Chain Saw and Battery
- 22 Cleaning
- 23 Inspection and Maintenance
- 24 Troubleshooting Guide
- 25 Specifications
- 26 CSA Standard
- 27 Combinations of Guide Bars and Saw Chains
- 28 Replacement Parts and Equipment
- 29 Disposal
- 1 Préface
- 2 Indications concernant la présente Notice d'emploi
- 3 Principales pièces
- 4 Symboles de sécurité sur les produits
- 5 CONSIGNES DE SÉCURITÉ IMPORTANTES
- 6 Rebond et autres forces réactives
- 7 Techniques appropriées d’élagage
- 8 Sécurité de la batterie
- 9 Maintenance, réparation et rangement
- 10 Avant d'entreprendre le travail
- 11 Recharge de la batterie
- 12 DEL de diagnostic et signaux sonores
- 13 Batterie en sac à dos STIHL AR
- 14 Assemblage de la tronçonneuse
- 15 Le frein de chaîne
- 16 Insertion et retrait de la batterie
- 17 Mise en marche et arrêt de la tronçonneuse
- 18 Contrôle de la tronçonneuse
- 19 Après avoir terminé le travail
- 20 Transport de la tronçonneuse et de la batterie
- 21 Stockage de la tronçonneuse et de la batterie
- 22 Nettoyage
- 23 Inspection et maintenance
- 24 Guide de dépannage
- 25 Spécifications
- 25.1 STIHL MSA 161 T
- 25.2 Pignons
- 25.3 Profondeur de rainure minimale des guide- chaines
- 25.4 Réglage de la jauge de profondeur
- 25.5 Symboles sur la tronçonneuse
- 25.6 Améliorations technologiques
- 25.7 Déclaration de conformité de l'appareil et du chargeur avec la directive CEM (sur la compatibilité électromagnétique)
- 26 Norme CSA
- 27 Combinaisons de guide-chaînes et de chaînes coupantes
- 28 Pièces de rechange et équipement
- 29 Élimination
0458-791-8221-C
30
English
13 STIHL AR Backpack Battery
The connecting cord can run through the guides on the
shoulder strap (Illustration A) or along the back
plate (Illustration B). Secure the connecting cord to the
backpack with the hook and eye fasteners (1) on the right
side of the operator's body, where the chain saw is held and
controlled. Do not allow the connecting cord to swing across
your body or hang at your side.
The length of the connecting cord can be adjusted by
making a loop around the top (Illustration C) or on the side
(Illustration D) of the backpack battery.
► Position and secure the connecting cord so that it will not
interfere with proper working technique or your ability to
maintain control of the chain saw.
13.2 Putting on and Adjusting the Harness
WARNING
To reduce the risk of personal injury, the operator must be
able to remove the backpack battery quickly in the event of
an emergency. In an emergency, open and remove the waist
belt and chest strap quickly before dropping the battery to
the ground.
To ensure a proper fit:
► Put the backpack battery on your back.
► Fasten and adjust the waist belt (2) so that it rests
comfortably but securely on your hips.
► Fasten the chest strap (1) and adjust it so that it fits
comfortably but securely across your chest.
► Adjust the harness straps so that the back padding fits
firmly and securely against your back.
► Thread the end of the waist belt through the loop (3).
0000-GXX-7802-A0
1
1
1
1
1
1
B
A
0000-GXX-2803-A1
D
C
1
0000-GXX-7803-A0
0000-GXX-2815-A1
3