Instruction Manual
Table Of Contents
- STIHL RE 150 PLUS, 170 PLUS
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Safety instructions - Accessories
- 6 Preparing the pressure washer for operation
- 7 Assembling the pressure washer
- 8 Connecting to a water source
- 9 Connecting the pressure washer to the power supply
- 10 Switching the pressure washer on and off
- 11 Operating the pressure washer
- 12 After Finishing Work
- 13 Transporting
- 14 Storing
- 15 Cleaning
- 16 Maintenance
- 17 Repairing
- 18 Troubleshooting
- 19 Specifications
- 20 Spare Parts and Accessories
- 21 Disposal
- 22 EC Declaration of Conformity
Pipe cleaning kit
WARNING
1
0000-GXX-5101-A0
■
The pipe cleaning hose increases the reaction
forces. If the spray gun lever is pressed and
the pipe cleaning hose is outside the pipe, the
pipe cleaning hose may turn uncontrolled. The
user may lose control of the pipe cleaning
hose. The user may be seriously injured and
property damage may occur.
►
Only switch on the high-pressure cleaner
and press the spray gun lever when the
pipe cleaning hose has been pushed into
the pipe up to the mark (1).
►
When the mark on the pipe cleaning hose is
visible when it is pulled out:
–
Release spray gun trigger
–
Switch off pressure washer
–
Turn off water supply
–
Actuate spray gun: The water pressure
is released
–
Lock spray gun trigger
■
Within a large pipe, the pipe cleaning hose
can change direction and come out of the
opening of the pipe again. The user may lose
control of the pipe cleaning hose. The user
may be seriously injured and property damage
may occur.
►
Watch the pipe.
► If the nozzle comes out of the pipe from the
pipe cleaning hose:
–
Release spray gun trigger
–
Lock spray gun trigger
–
Switch off pressure washer
Angled spray lance and angled nozzle
WARNING
■
An angled spray lance and the angled nozzle
increase the lateral reaction forces. The user
may lose control of the spraying system due to
the reaction forces that occur. The user may
be seriously injured and property damage may
occur.
►
Only attaching a jet pipe extension
► Hold the spray gun with both hands.
► Work as described in this manual.
6 Preparing the pressure
washer for operation
6.1 Making the pressure washer
ready for use
The following steps must be carried out every
time before starting work:
►
4.6
►
Clean the pressure washer, 15.1.
► If a water filter is used: Check water filter for
dirt and clean if dirty, 15.4.
► Set up the pressure washer on a firm and level
base, where it will not slide or tip over.
►
Unroll high-pressure hose from hose reel,
11.2.
►
Connect spray gun, 7.3.1.
►
Fit spray lance, 7.4.1.
►
If a nozzle is used: Attach nozzle, 7.5.1.
► If a detergent is used: Working with detergent
and detergent container, 11.6.3.
►
If using an accessory: Fit accessory, 5.1.
►
Connect water supply, 8.1.
►
Connect pressure washer to power supply,
9.1.
► If it is not possible to carry out these steps: Do
not use the pressure washer and consult a
STIHL servicing dealer.
7 Assembling the pressure
washer
7.1 Assembling the pressure
washer
Insert nozzles and cleaning pin
1
3
2
4
0000-GXX-9166-A0
► Open flap (1).
► Insert fan-jet nozzle (2) and rotary nozzle (3).
► Insert cleaning pin (4).
6 Preparing the pressure washer for operation English
0458-663-0121-B 11