Instruction Manual

RE 362, RE 362 PLUS, RE 462, RE 462 PLUS
English
51
N Turn the knob (3) to set the working
pressure and water flow rate
The pressure in the high-pressure pump
is indicated by a pressure gauge (4).
The indicated pressure is not always the
same as the pressure in the spray lance
before the nozzle. The pressure before
the nozzle depends on the position of
the pressure/quantity control lever on
the spray gun.
Pressure/quantity control on the spray
gun
The working pressure and water volume
can be set on the spray gun for short-
term adjustment in line with the cleaning
task.
Standard setting
Move the setting lever to standard
position: Maximum working pressure
and water flow rate.
Reduced working pressure and water
flow rate
The setting lever can be used to adjust
the working pressure and water flow rate
in fine increments.
Pressure control at the nozzle
The operating pressure can be infinitely
adjusted at the nozzle.
N Turn the nozzle sleeve – the
quantity of water delivered remains
unchanged
High-pressure hose
NOTICE
Do not buckle or loop the high-pressure
hose.
Do not place any heavy objects on the
high-pressure hose, and do not drive
any vehicles over it.
Machines with hose reel
The high-pressure hose can be
disconnected either from the front or
back of the machine with the folding
cliplock.
N Undo the hose reel brake (1)
N Fold the cliplock forward or
backward
Standby mode
NOTICE
The machine must not be operated in
standby mode for more than 5 minutes.
If work is interrupted for more than
5 min., during breaks or if the machine is
left unattended, switch off the machine
at the master switch – see "Switching off
the machine".
Only RE 462, RE 462 PLUS
Safety shutdown
If the switched on machine is not
operated, it disconnects from the power
mains automatically after 30 minutes.
4
3
9937BA013 KN
671BA027 KN
671BA024 KN
647BA025 KN
1
9937BA014 KN