Instruction Manual

7 Checking the KombiTool
7.1 Checking the Blades
► Switch off the KombiMotor.
a
b
c
0000-GXX-8740-A0
► Measure the following points on the blades:
–
Length a
–
Width b
–
Angle c
►
Compare measurements, 15.2.
► If the minimum length is less than specified:
Offset the blades, 13.4.
► If the minimum width is less than specified:
Replace the blades, 13.3.
► If the filing angle is not correct: Sharpen the
blades, 13.5.
► If you have any queries: Contact a STIHL
servicing dealer for assistance.
8 Using the KombiTool
8.1 Holding and Controlling the
KombiTool
2
1
0000-GXX-7807-A0
► Hook the KombiMotor’s carrying ring (2) to the
carrying system’s carabiner (1).
KombiMotor with loop handle.
0000-GXX-4644-A0
► Hold the KombiMotor with your right hand on
the control handle – wrap your thumb around
the control handle.
► Hold the KombiMotor with your left hand on
the loop handle – wrap your thumb around the
loop handle.
KombiMotor with bike handle
0000-GXX-7850-A0
► Hold the KombiMotor with your right hand on
the control handle – wrap your thumb around
the control handle.
► Hold the KombiMotor with your the left hand
on the handle – wrap your thumb around the
handle.
8.2 Weeding and Mowing Grass
The cutting height is determined by the distance
of the blades from the ground.
0000-GXX-8737-A0
► Swing the KombiTool back and forth in an arc.
► Walk slowly and steadily forwards.
9 After Finishing Work
9.1 After Finishing Work
► Switch off the KombiMotor.
► If the KombiTool is wet: Allow KombiTool to
dry.
► Clean the KombiTool.
► Fit the transport guard.
10 Transporting
10.1 Transporting the KombiTool
► Switching the KombiEngine Off.
► Fit the transport guard.
7 Checking the KombiTool English
0458-811-0121-B 7