Instruction Manual

ENES
13
PTNOSVFIDAELBGUK
0478 121 9804 B - EN
Switch off the motor, disconnect
the mains plug from the socket
and ensure that the cutting tool
has come to a complete
standstill
– before remedying blockages, including
those in the discharge chute;
– if the cutting tool has hit a foreign object.
The cutting tool needs to be checked for
possible damage. The machine must
not be operated with a damaged or bent
blade shaft or motor shaft. Risk of
injury through defective parts!
– before you check, clean or carry out
work on the machine (e.g. adjusting the
cutting height, folding down/adjusting
the handlebar);
– before leaving the machine unattended;
– before lifting or carrying the machine;
– before transporting the machine;
– after hitting a foreign object or if the
machine vibrates excessively. In these
cases check the machine, in particular
the cutting unit (blade, blade shaft,
blade fastening), for damage and carry
out the necessary repairs before
restarting and working with the
machine.
Owing to the voltage fluctuations caused
by this machine during the run-up period,
other devices connected to the same
circuit may be subject to interference in the
case of unfavourable power supply
conditions. In this case, appropriate steps
should be taken (e.g. connection to a
different circuit than the one used by the
affected device, or operation of the
machine using a circuit with a lower
impedance).
4.7 Maintenance, cleaning, repairs and
storage
Before performing any work on
the machine, before adjusting or
cleaning the machine, or before
checking whether the electric
cable is entwined or damaged, switch off
the machine and disconnect the mains
plug from the socket.
Allow the machine to fully cool down
before storing it in enclosed places,
performing maintenance on it or cleaning
it.
Cleaning:
The complete machine must be cleaned
thoroughly following use. (Ö 11.2)
Remove accumulated clipping deposits
using a stick. Clean the underside of the
mower with water and a brush.
Never use high-pressure cleaners and do
not clean the machine under running water
(e.g. using a garden hose).
Do not use aggressive cleaning agents.
These can damage plastics and metals,
impairing the safe operation of your STIHL
machine.
In order to prevent fire hazards, keep the
area around the air vents between the
motor hood and housing free from
e.g. grass, straw, moss, leaves or
escaping grease.
Maintenance operations:
Only maintenance operations described in
this instruction manual may be carried out.
Have all other work performed by a
specialist dealer.
If you do not have the necessary expertise
or auxiliary equipment, please always
contact a specialist dealer.
STIHL recommends that you have
maintenance operations and repairs
performed exclusively by a STIHL
specialist dealer.
STIHL specialist dealers regularly attend
training courses and are provided with
technical information.
Only use tools, accessories or
attachments approved for this machine by
STIHL or technically identical parts.
Otherwise, there may be a risk of
accidents resulting in personal injury or
damage to the machine. If you have any
questions, please consult a specialist
dealer.
The characteristics of original STIHL tools,
accessories and spare parts are optimally
adapted to the machine and the user's
requirements. Genuine STIHL spare parts
can be recognised by the STIHL spare
parts number, by the STIHL lettering and,
if present, by the STIHL spare parts
symbol. On smaller parts, only the symbol
may be present.
Always keep warning and information
stickers clean and readable. Damaged or
missing stickers must be replaced by new,
original plates from your STIHL specialist
dealer. If a component is replaced with a
Risk of injury!
Strong vibration is normally an
indication of a fault.
In particular, the machine must not
be operated with a damaged or
bent blade shaft or mowing blade.
If you do not have the appropriate
expertise, have the necessary
repairs carried out by a specialist
dealer (STIHL recommends STIHL
specialist dealers).