Instruction Manual

SE 122, SE 122 E
English
23
N Push filter bag sleeve onto intake
port as far as possible (see
instructions on filter bag)
N Refit the upper part of the vacuum
cleaner (2) and close the latches (1)
– ensure that the latches engage
properly
N Push the suction hose into the
connector
N Push the handle tube (3) into the
sleeve of the suction hose
N Push extension tube (4) onto the
handle tube
To connect other tools (e. g., grinding
machine):
N Fit adapter for power tools (5)
(supplied with the model SE 122 E)
to suction hose instead of handle
tube
N Mount extension tube holder at a
distance (A) of approx. 20 cm from
the bottom edge of the extension
tube
N Depending on the intended use of
the vacuum, fit the crevice tool (6),
all-purpose tool (7) or floor tool (8)
onto the extension tube.
The voltage and frequency of the
machine (see rating plate) must match
the voltage and frequency of the power
connection.
The minimum fuse protection of the
power connection must comply with the
specifications – see "Specifications".
The machine must be connected to the
power supply via an earth-leakage
circuit breaker to disconnect the power
supply if the differential current to earth
exceeds 30 mA.
The power connection must correspond
to IEC 60364 and relevant national
regulations.
Extension cord
The design of the extension cord must at
least fulfill the same features as the
connecting cord on the machine.
Observe the design marking (type
designation) on the connecting cord.
The cores in the cord must have the
following minimum cross-section
depending on the mains voltage and
cord length.
649BA002 KN
3
649BA003 KN
4
5
649BA004 KN
A
649BA005 KN
6
8
7
Connecting to Power Supply
Cord length Minimum cross-
section
220 V – 240 V:
Up to 20 m 1.5 mm
2
20 m to 50 m 2.5 mm
2
100 V – 127 V:
Up to 10 m AWG 14 / 2.0 mm
2
10 m to 30 m AWG 12 / 3.5 mm
2