Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing the wet/dry vacuum cleaner for use
- 6 Assembling the wet/dry vacuum cleaner
- 7 Switching the wet/dry vacuum cleaner on and off
- 8 Checking the wet/dry vacuum cleaner
- 9 Using the wet/dry vacuum cleaner
- 10 After Finishing Work
- 11 Transporting
- 12 Storing
- 13 Cleaning
- 14 Maintenance
- 15 Repairing
- 16 Troubleshooting
- 17 Specifications
- 18 Spare Parts and Accessories
- 19 Disposal
- 20 EC Declaration of Conformity
0458-660-0121-A
24
English
16 Troubleshooting
The suction power is too
low.
The suction power is set too low. ► Set the suction power.
The filter bag or the container is full. ► Replace filter bag or empty the container.
The filter is dirty. ► Switch on automatic filter cleaning.
► Clean or replace the filter.
The suction hose, the hand tube or the
accessory is blocked up.
► Clean the suction hose, hand tube or
accessory.
The seal between the top part and the container
is dirty or damaged.
► Clean seal between top part and container or
ask a STIHL authorized dealer to replace it.
The air flow rate is less
than 20 m/s. The air
velocity monitoring LED in
the suction hose lights up
and a succession of short
beeps is heard.
The diameter of the suction hose is not set
correctly.
► Set the diameter of the suction hose.
The filter bag or the container is full. ► Replace filter bag or empty the container.
The filter is dirty. ► Clean or replace the filter.
The suction hose, the hand tube or the
accessory is blocked up.
► Clean the suction hose, hand tube or
accessory.
The seal between the top part and the container
is dirty or damaged.
► Clean seal between top part and container or
ask a STIHL authorized dealer to replace it.
Fault Cause Remedy