Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing the wet/dry vacuum cleaner for use
- 6 Assembling the wet/dry vacuum cleaner
- 7 Switching the wet/dry vacuum cleaner on and off
- 8 Checking the wet/dry vacuum cleaner
- 9 Using the wet/dry vacuum cleaner
- 10 After Finishing Work
- 11 Transporting
- 12 Storing
- 13 Cleaning
- 14 Maintenance
- 15 Repairing
- 16 Troubleshooting
- 17 Specifications
- 18 Spare Parts and Accessories
- 19 Disposal
- 20 EC Declaration of Conformity
0458-660-0121-A
25
English
17 Specifications
17.1 Wet/dry vacuum cleaner STIHL SE 133 ME
– Rated voltage: see rating plate
– Frequency: see rating plate
–Fuse:
–16A
– Switzerland, Australia, New Zealand only: 10 A
– Power consumption to EN 60335-2-69: 1200 W
– Power consumption power tool socket:
– 2400 W
– Switzerland, Australia, New Zealand only: 1100 W
– Electrical protection class: I
– Degree of electrical protection: IPX4 (protection against
splash water from any direction)
– Maximum air throughput (measured at the turbine):
4500 l/min
– Maximum vacuum: 250 mbar
– Dimensions
– Length: 565 mm
– Width: 385 mm
– Height: 605 mm
– Dimensions of suction hose: Ø 32 mm x 5 m
– Length of connecting cord: 7.5 m
– Maximum container capacity: 42 l
– Weight with accessory attached: approx. 16 kg
17.2 Extension Cords
If an extension cord is used, the cross sectional area of its
conductors must meet the following minimum requirements
– depending on the line voltage and length of the extension
cord:
220 V to 240 V
– Cord length up to 20 m: AWG 15 / 1.5 mm²
– Cord length 20 m up to 50 m: AWG 13 / 2.5 mm²
100 V to 127 V
– Cord length up to 10 m: AWG 14 / 2.0 mm²
– Cord length 10 m up to 30 m: AWG 12 / 3.5 mm²
17.3 Sound and Vibration Levels
– Sound pressure level L
pA
measured according to
EN 60335-2-69: 68 dB(A). The K value for the sound
pressure level is 2 dB(A).
– Vibration level a
h
measured according to ISO 5349, hand
tube: ≤ 2.5 m/s².
Information regarding compliance with the Employers’
Directive on Vibration 2002/44/EC can be found at
www.stihl.com/vib.
17.4 REACH
REACH is an EC regulation and stands for the Registration,
Evaluation, Authorisation and Restriction of Chemical
substances.
For information on compliance with the REACH regulation
see www.stihl.com/reach.
18.1 Spare Parts and Accessories
STIHL recommends the use of original STIHL replacement
parts and accessories.
17 Specifications
18 Spare Parts and Accessories
These symbols identify original STIHL
replacement parts and original STIHL
accessories.