Operation Manual

16
English / USA
BG 55, BG 65, BG 85, SH 55, SH 85
: Do not let the starter grip snap back.
Guide it slowly back into the housing
so that it can rewind properly.
If the engine is cold:
(choke position g)
: Pull the starter rope five times.
: Move the choke lever (5) to e
: Continue cranking until engine runs.
If the engine does not start after 10
pulls with the choke lever set to e :
Set choke to g , pull the starter
rope five times, set choke to e and
continue cranking.
If engine is warm:
: Continue cranking until engine runs
(choke lever to e )
As soon as engine runs
: BG 55, 65, SH 55
Blip the throttle trigger so that
interlock button pops out and the
engine settles down to idle speed
: BG 85, SH 85
Move setting lever forwards to end
position.
If the engine stops during warm-up or
acceleration:
: Repeat starting procedure as
described under “If engine is cold”
Your unit is now ready for operation.
To stop the engine:
: Move switch to position O
Additional hints on starting
- If the engine does not start:
: Make sure all settings are correct
(choke shutter, throttle trigger
in starting throttle position, stop
switch to I)
: Repeat the starting procedure
- If the engine still does not start:
: Move switch to O
: Pull off the spark plug boot (7).
: Unscrew and dry off the spark plug.
: Open throttle wide.
: Crank the engine several times with
the starter to clear the combustion
chamber.
295BA043 KN
5
7
295BA017 KN