Operation Manual

BG 56, BG 56 C, BG 66, BG 66 C, BG 86, BG 86 C, SH 56, SH 56 C, SH 86, SH 86 C
English
16
Starting
N Place the unit on the ground:
N Make sure you have a firm footing:
Hold the unit firmly with your right
hand on the housing and press
down.
N Hold the starter grip with your left
hand.
Models with ErgoStart
N Pull the starter grip steadily.
Models without ErgoStart
N Pull the starter grip slowly until you
feel it engage and then give it a brisk
strong pull.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Other hints on starting
If the engine stops while the choke
knob in on g or during acceleration
N Move the choke knob to < and
continue cranking until the engine
runs.
If the engine does not start
N Make sure all settings are correct
(choke knob, setting lever in run
position F).
N Repeat the starting procedure.
If fuel tank has been run completely
dry and then refueled
N Press the fuel pump bulb (1) at least
five times – even if the bulb is filled
with fuel.
N Now start the engine.
As soon as the engine runs
N Blip the throttle trigger (3) – the
choke knob moves to the run
position F – the engine returns to
idle speed.
Stopping the Engine.
BG 56, BG 66, SH 56
N Move the stop switch to 0 – the
engine stops – the stop switch
springs back to the on position.
Do not pull out the starter rope all
the way – it might otherwise
break.
296BA006 KN
1
295BA066 KN
295BA071 KN
3
295BA072 KN