Instruction Manual

SR 200
English
14
fire agency or forest service for the laws
or regulations relating to fire protection
requirements.
Tighten all nuts, bolts and screws except
the carburetor adjustment screws after
each use.
For maintenance items please also refer
to the maintenance chart in this
instruction manual.
Store the power tool in a dry and high or
locked location out of reach of children.
Before storing for longer than a few
days, always empty the fuel tank. See
chapter "Storing the machine" in this
instruction manual.
Store fuel in an approved and properly
labeled safety-type canister only. Take
care when handling gasoline! For health
and safety reasons, avoid direct contact
with the skin and avoid inhaling fuel
vapor!
NOTICE
The solution hose and throttle cable are
already connected and must not be
kinked while assembling the machine.
The combination wrench and
screwdriver are in the supplied
accessory bag.
Fitting the pleated hose on the elbow
N Open the hose clamp (1) and fit it on
the pleated hose (2).
N Engage the tab in the recess.
N Push the pleated hose (2) over the
slip ring (3) as far as stop.
N Line up the hose clamp (1) and slip
ring (3):
– the two lugs (arrow) on the slip ring
face up.
– The hose clamp's hook faces
outwards.
N Tighten down the screw (arrow).
Mounting the Control Handle
N Open up the control handle (1) with
liner (2) and push it over the stub (3)
of the pleated hose.
Assembling the Unit
1
2
9928BA001 AM
3
2
2431BA017 KN
3
1
2431BA002 KN
9928BA019 AM
3
2431BA003 KN
1
2