Instruction Manual

SR 200
English
20
Before Starting
N Close valve lever (1) for solution
feed.
Start the engine.
N Observe safety precautions.
NOTICE
Start your unit on a clean, dust-free
surface only to ensure that no dust is
sucked in.
N The setting lever must be on F
N Press the manual fuel pump bulb at
least five times – even if the bulb is
filled with fuel.
Cold Engine (cold start)
N Turn the choke knob to g.
Warm Engine (warm start)
N Turn the choke knob to <.
Also use this setting if the engine has
been running but is still cold.
Cranking
N Place the unit securely on the
ground and make sure that
bystanders are well clear of the
nozzle outlet.
N Make sure you have a firm footing:
Hold the unit with your left hand on
the container and put one foot
against the base plate to prevent it
from slipping.
N Pull the starter grip slowly with your
right hand until you feel it engage
and then give it a brisk strong pull.
Do not pull out the starter rope to full
length – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
N Continue cranking until the engine
runs.
Starting / Stopping the
Engine
0002BA060 KN
1
0002BA019 KN
9928BA006 AM9928BA007 AM
9928BA008 AM
2431BA009 KN