Instruction Manual

TS 410, TS 420
English
30
Removing a cutting wheel
N Use the combination wrench to
loosen and remove the hexagon
head screw (2)
N Remove the front thrust washer (3)
from the shaft together with the
cutting wheel
Fitting a new cutting wheel
N Fit the new cutting wheel (4)
WARNING
Note the arrows indicating the direction
of rotation on diamond cutting wheels.
N Fit the front thrust washer (3). The
catches of the front thrust
washer (3) must engage in the shaft
grooves.
N Screw in the hexagon bolt and
tighten it with the combination
wrench – if using a torque wrench,
refer to the "Specifications" for the
tightening torque
N Draw the locking pin out of the
V
-
belt guard
WARNING
Never use two cutting wheels at the
same time. The uneven wear creates a
risk of breaking and an injury hazard!
2
370BA053 KN
370BA054 KN
4