Instruction Manual

TS 410, TS 420
English
34
For all versions
N Press the bulb (6) of the manual fuel
pump 7
-
10 times – even when the
bulb is still filled with fuel
Starting
N Place the cut-off machine carefully
on the ground, ensuring that the
abrasive wheel cannot touch the
ground or any objects. There must
not be anyone within the swivel
range of the cut-off machine
N Make sure you have a firm footing
N Press the cut-off machine firmly
against the ground, holding the
handle with your left hand, thumb
wrapped round the handle
N Press the cut-off machine against
the ground with the right knee on the
shroud
N Pull the starter grip slowly with your
right hand until you feel it engage –
then give it a brisk strong pull – do
not pull out the starter rope all the
way
NOTICE
Do not let the starter grip snap back – it
may break! Guide it back into the
housing in the opposite direction so that
it can rewind properly.
When the engine has turned over for the
first time
N Set the choke lever (4) to f
N Press the button of the
decompression valve (depending
on version)
N continue cranking
Once the engine is running
N Squeeze throttle trigger fully and let
engine run at full throttle for
approx. 30 s
N When it has warmed up, set the
choke lever to e
N The slide control (3) moves to the
normal positionF when the throttle
trigger is squeezed
6
370BA102 KN
370BA092 KN
4
370BA057 KN
Choke
370BA058 KN
START
3