Instruction Manual

TS 410, TS 420
English
41
N Fit the starter cover (5) over the
studs (10)
N Tighten up the nuts (1) by hand
N Push the V
-
belt guard (4) into place
N Screw in the bolt (3) and tighten up
N Insert the water hose into the guide
in the V
-
belt guard (arrow) from the
shut-off cock towards the guard –
avoid tight radiuses
Continue as described in the chapter
“Tensioning the V
-
belt”.
The cut-off machine can be mounted on
the STIHL cut-off machine cart FW 20
(special accessory) in a few easy steps.
The cut-off machine cart makes it easier
to
– repair damaged roadways
– apply roadway markings
– cut expansion joints
If the machine is to remain out of use for
approx. 3 months or more
N Drain and clean the fuel tank in a
well ventilated place
N Dispose of fuel in accordance with
the regulations and having regard
for the environment
N Run the engine until the carburetor
is dry, this helps to prevent the
carburetor diaphragms sticking
together
N Remove the abrasive wheel
N Thoroughly clean the machine
N Store machine in a safe and dry
place. Protect against unauthorized
use (e. g., by children)
10
1
10
10
370BA064 KN
1
5
1
4
3
370BA065 KN
Cut-off machine cart
1307BA027 KN
Storing the Machine