Operators Manual

TS 410, TS 420
English
12
N Work along the cutting line. When
making corrections, do not tilt the
abrasive wheel, but always set the
abrasive wheel against the
workpiece anew – the cutting depth
for each operation should not
exceed 5 to 6 cm. Cut thicker
material in multiple operations
Cutting plates
N Secure the plate (e. g. on a non-slip
surface, sandbed)
N Grind a guide groove (A) along the
line marked
N Make the cut (B) deeper
N Leave a "hinge" (C)
N First sever the plate at the cut ends
so that no material breaks away
N Break plate
N Make curves in multiple operations
– make certain that the abrasive
wheel does not tilt
Cutting pipes, round and hollow bodies
N Secure pipes, round and hollow
bodies against vibrations, slipping
and rolling away
N Note direction of fall and weight of
the severed part
N Determine and mark the cutting line,
avoid reinforcement, especially in
the direction of the severing cut
N Determine sequence of severing
cuts
N Grind a guide groove along the line
marked
N Make cut deeper along the guide
groove – observe the recommended
cutting depth for each operation –
for small corrections of direction, do
not tilt the abrasive wheel, but
always position it anew instead – if
necessary, leave small ridges that
hold the part that is to be separated
in position. Break these ridges after
the last planned cut
Cutting concrete pipe
The procedure is dependent on the
outer diameter of the pipe and the
maximum possible cutting depth of the
abrasive wheel (A).
N Secure pipe against vibrations,
slipping and rolling away
N Note weight, tension and direction
of fall of the part to be severed
180BA027 AM
180BA028 AM
A
002BA557 AM