Operators Manual

TS 410, TS 420
English
13
N Determine and mark direction of cut
N Determine sequence of cuts
Outer diameter is smaller than the
maximum cutting depth
N Make one cut from the top to the
bottom
Outer diameter is greater than the
maximum cutting depth
Plan first, then cut. Several cuts are
needed – correct sequence is important.
N Turn guard at rear stop
N Always start at the bottom, use the
upper quarter of the abrasive wheel
for cutting
N Use the upper quarter of the
abrasive wheel for cutting the
opposite lower side.
N First lateral cut on the top half of the
pipe
N Second lateral cut in the marked
area – never cut into the area of the
last cut, to ensure a firm hold on the
part of pipe to be cut
Only make the last top cut once all
bottom and lateral cuts have been
made.
N Last cut always from the top
(approx. 15 % of the pipe
circumference)
Concrete pipe – cut recess
Sequence of cuts (1 to 4) is important:
N First, cut hard-to-reach areas
002BA528 AM
002BA558 AM
002BA560 AM002BA561 AM002BA562 AM 002BA563 AM
002BA559 AM