Operators Manual

TS 410, TS 420
English
39
Engine
STIHL single cylinder two-stroke engine
TS 410
TS 420
Ignition system
Electronic magneto ignition
Fuel system
All-position diaphragm carburetor with
integral fuel pump
Air filter
Main filter (paper filter) and flocked wire
mesh auxiliary filter
Weight
Abrasive wheels
The quoted maximum permissible
operating speed of the abrasive wheel
must be greater than or equal to the
maximum spindle speed of the cut-off
machine used.
Abrasive wheels (TS 410)
Abrasive wheels (TS 420)
Specifications
Displacement: 66.7 cm
3
Cylinder bore: 50 mm
Piston stroke: 34 mm
Engine power accord-
ing to ISO 7293:
3.2 kW (4.4 HP)
at 9000 rpm
Idle speed: 2500 rpm
Max. spindle speed to
ISO 19432: 5080 rpm
Displacement: 66.7 cm
3
Cylinder bore: 50 mm
Piston stroke: 34 mm
Engine power accord-
ing to ISO 7293:
3.2 kW (4.4 HP)
at 9000 rpm
Idle speed: 2500 rpm
Max. spindle speed to
ISO 19432: 4880 rpm
Spark plug
(suppressed): Bosch WSR 6 F
Electrode gap: 0.5 mm
Fuel tank capacity: 710 cm
3
(0.71 l)
without fuel, without abrasive wheel,
with water attachment
TS 410: 9.4 kg
TS 420: 9.6 kg
Without fuel, without abrasive wheel,
with electronic water control
TS 410: 9.9 kg
TS 420: 10.1 kg
Outside diameter: 300 mm
Max. thickness: 4.8 mm
Bore diameter/spindle
diameter: 20 mm
Tightening torque: 30 Nm
Composite resin abrasive wheels
Minimum outside diameter of
thrust washers: 103 mm
Max. depth of cut: 100 mm
Diamond abrasive wheels
Minimum outside diameter of
thrust washers: 103 mm
Max. depth of cut: 100 mm
Outside diameter: 350 mm
Max. thickness: 4.8 mm
Bore diameter/spindle
diameter: 20 mm
Tightening torque: 30 Nm
Composite resin abrasive wheels
Minimum outside diameter of
thrust washers:
1) 2)
103 mm
Maximum cutting depth:
3)
125 mm
1)
For Japan 118 mm
2)
For Australia 118 mm
3)
When using thrust washers with an
outside diameter of 118 mm, the
maximum cutting depth is reduced
to 116 mm
Diamond abrasive wheels
Minimum outside diameter of
thrust washers:
1)
103 mm
Maximum cutting depth:
3)
125 mm
1)
For Japan 118 mm
3)
When using thrust washers with an
outside diameter of 118 mm, the
maximum cutting depth is reduced
to 116 mm