Use and Care Manual

www.nationalnail.com

OPERATING THE TOOL

1. Do not use tool prior to reading the Owner’s Manual.

2. Read warning label(s) on the tool.

3. Visually inspect the tool for worn or damaged parts.

4. Wear appropriate eye and ear protection.

5. Install a male pneumatic fitting into the end cap of the tool, ensuring that the fitting allows the

tool to exhaust any air in the tool when the air hose is disconnected.

6. Add 2 drops of non-detergent, 20-weight oil into the male fitting.

7. Connect the air hose using a quick connect fitting to the tool, and check the air pressure

reading on the regulator to ensure it does not exceed 105 PSI. Check the tool for any air

leaks.

8. Place the tool, empty of fasteners, in operating position on a scrap work piece. Fully depress

the safety and pull the trigger to verify that the tool cycles.

9. Disconnect the air hose from the tool when:

• Loading staples and/or caps

• Performing inspection, maintenance or repair

• Clearing a staple or collated cap jam

• The tool is not in use

• Leaving the work area

• Moving the tool to another work location

• Handing the STINGER CS58 to another person

• Storing the tool

10. Following recommended loading instructions, load the fasteners approved for use in the tool.