Installation Guide

Stinger HEIGH10 Radio Replacement Kit

for select 2014-2019 Silverado/Sierra Truck

SR-GM14H

Pacific Accessory Corporation

Page 7

Rev: V1

Date: 030121

Step 3Step 2

Step 1

Step 4

Install the optional USB cover and

feed the USB cables through the

front of the panel. Secure with the

anged nut and then lock with the

lock nut.

Remove the plastic sleeve by

depressing the two tabs and

pushing out the front.

From the backside of the lower

storage compartment, remove the

metal insert from the power outlet

by releasing the two retaining clips

with a small pick and pushing out

the front side.

Route the USB cables up and out

of the right side opening at the

rear of the CD/DVD opening.

Section 2: In-Vehicle Harness Connections and Preparation

Part One: Dual USB Extension (SSUSB2)

Apple CarPlay, Android Auto, and any Firmware Updates require access to a USB port. The SSUSB2 is designed to extend the

USB ports on the back of the HEIGH10 to where they are accessible once the radio is installed.

For this installation, the factory 12V power outlet will be replaced with the SSUSB2. You may chose to follow these steps, or

mount the USB port somewhere else in the vehicle. Please note, the factory USB ports will no longer function after the factory

radio is removed.