Installation Guide

Stinger HEIGH10
®
Radio Replacement Kit
for 2011-2018 Jeep Wrangler JK
SR-JK11H
© 2021 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
AAMP Global is not a󰀩liated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identication purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation
Page 12
Rev: V2
Date:052521
®
Step 8
Install the front frame by hooking
at the top rst, then snapping in
the sides and bottom. Remove
the tape by pulling downward.
Part Three: Attaching the Display Panel (cont.)
Section 4: Radio Unit Installation (cont.)
Step 7
Once the display panel is
locked into place, use a Phillips
screwdriver to tighten the two mount
screws on the left and right sides of
the mounting panel.
Product Updates (Firmware)
Reset / Restoring Interface Factory Settings
You can restore the RadioPRO interface module to factory default settings by pressing and holding the programming button
on the side of the module until the status LED starts blinking red. Once the LED starts blinking red, release the button. You
must release the button while the LED is blinking red in order to perform the reset. This reset will restore all settings to factory
defaults.
Email: [e-mail]
Phone: [phone]
International: 727-592-5991
Technical Support
Firmware Updates (Stinger HEIGH10 )
To update the Stinger radio rmware, refer to the HEIGH10 product page at:
www.stingerelectronics.com/products/heigh10
Firmware Updates (PAC RadioPRO)
The RP4-CH11 can be updated with new rmware as it becomes available using the PAC-UP interface updater (sold
separately). Please visit www.pac-audio.com/rmware for available updates.
Reinstall the remaining screws, panels and switch pod to complete the installation