Installation Guide

Stinger HEIGH10

Radio Replacement Kit

for 2011-2018 Jeep Wrangler JK

SR-JK11H

AAMP Global is not a󰀩liated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms

OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identication purposes only. It is not

implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.

Pacific Accessory Corporation

Page 13

Rev: V2

Date:052521

Removing the Display Panel

Step 5

Step 3

Step 1 Step 2

While holding the display with

one hand, insert a soft plastic

panel tool under either bottom

corner and slightly pry up to

release the display panel.

Once the side clips are

disengaged, swing the bottom

edge upwards to unhook the top

of the frame and remove.

Remove the front frame by rst

releasing the side clips at the

locations indicated by arrows.

Using a very thin pry tool or

similar, carefully release the side

clips as shown on both sides.

Step 4

Using a Phillips screwdriver, remove

the two mounting screws on the

left and right sides of the mounting

panel.